One of the most common reasons for a gas pole saw not starting is insufficient or stale fuel. Ensure that there is an adequate supply of fresh fuel in the gas tank. The second main reason is Faulty Spark Plug. A faulty or dirty spark plug can prevent your Remington gas pole saw from starting. Remove the spark plug and inspect its condition. Look for signs of wear, fouling, or deposits.
Check out more step-by-step guides on How to Fix a Remington Gas Pole Saw That Won’t Start.
Troubleshooting a Remington Gas Pole Saw That Won’t Start (Step-by-Step)
Check the Fuel
The first step in troubleshooting a gas pole saw that won’t start is to check the fuel. Ensure that there is enough fuel in the tank and that it is fresh. Gasoline can degrade over time, so if the fuel in your pole saw is more than a month old, it’s best to replace it with fresh gasoline.
Inspect the Spark Plug
A faulty spark plug can prevent your gas pole saw from starting. Remove the spark plug and inspect it for any signs of damage or fouling. If the spark plug is dirty, clean it with a wire brush and replace it if necessary. Make sure the spark plug gap is set to the correct specification for your Remington gas pole saw model.
Clean the Air Filter
A dirty air filter can restrict airflow to the engine, making it difficult for your gas pole saw to start. Remove the air filter and clean it with warm, soapy water. Allow it to dry completely before reinstalling it. If the air filter is damaged or excessively dirty, consider replacing it.
Check the Carburetor
A clogged or improperly adjusted carburetor can cause starting issues in your gas pole saw. If you suspect a carburetor issue, it’s best to consult your owner’s manual or a professional technician for guidance on cleaning and adjusting the carburetor.
Inspect the Fuel Lines and Primer Bulb
Cracked or damaged fuel lines can prevent fuel from reaching the carburetor, making it difficult for your gas pole saw to start. Inspect the fuel lines for any signs of damage and replace them if necessary. Additionally, check the primer bulb for cracks or leaks, as this can also cause starting issues.
Test the Ignition Coil
A faulty ignition coil can prevent your gas pole saw from starting. To test the ignition coil, disconnect the spark plug wire and hold it near the engine while pulling the starter cord. If you see a strong spark, the ignition coil is likely functioning correctly. If there is no spark or a weak spark, consider replacing the ignition coil.
Examine the Recoil Starter
The recoil starter is responsible for turning the engine over when you pull the starter cord. If the recoil starter is damaged or not engaging properly, your gas pole saw may not start. Inspect the recoil starter for any signs of damage and replace it if necessary.
